Printing a few labels at at time?

If you’re printing a few labels at at time and want to re-use the sheet with the unused labels, here are some tips.
For example, if your using the Maco ML-3000 that is compatible with the Avery Label Avery 5160, after printing a few labels, you’ll have a sheet of labels with one or two labels taken off the the page. Make sure you print the labels at the bottom of the page so that when you print the next few labels, you can feed the used page of labels with the unused labels first into the printer.
If you’re using an Inkjet printer, just make sure that the labels are not at all peeling off. If you run a sheet through an Inkjet printer too many times, the labels might start peeling off because of the tight paths the paper takes around the rollers. This could become a huge problem and get stuck on the print head, and can ruin the print head and the carriage motor.
If you’re using a laser printer, running a page of labels through a few times can cause several problems. One problem is that the overexposure to the heat from the fuser can cause the labels to peel and jam in the fuser. Inspect your labels before feeding them through multiple times. Laser printers also leave a layer of toner on the whole page. It’s normally not noticeable if you’re printing just one page, one time, but if your printing one page multiple times, the page will become darker and darker with each successive print. If you have an old printer, the darkening problem will be more severe.

Advertisements

Tags: , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s


%d bloggers like this: